Description
Battery Compatibility
This product has been designed to mount the super-slim 100Ah battery from iTech World (SKU: ITECH100SS)
(Battery not included)
Please note that this bracket is not suitable for any other battery as it uses threaded holes in the iTech 100SS battery case.
Vehicle Compatibility
Suitable for RA model dual cab Rangers from July 2022 onward (Commonly known as “Next-Gen Ranger”), without the behind-seat speaker, or with the non-ported speaker that looks like this:
If your vehicle has a large plastic moulding for the “ported” sub woofer and looks like the next photo, there is no way to install a dual battery system behind the seat and this product will not fit.
This bracket and battery combination will fit:
- Next-Gen Ranger Raptor – July 2022 onward with non-ported sub woofer.
- Next-Gen Ranger Wildtrak with the premium audio – July 2022 onward with non-ported sub woofer.
- Next-Gen Ranger dual cab models without behind-seat speaker
Can also be used where the rear seats have been removed.
Installation Notes
No cutting or drilling of bodywork panels.
No cutting of the carpet on the wall.
Cabin vent stays in-place.
Upon removal of the battery and mount, the vehicle will look the same as it was the day it rolled off the production line.
In vehicles without the behind-seat speaker, one hole in the floor bracket where the speaker foot would be mounted needs to have an M6 thread tapped prior to installation. This can be done easily using an M6 thread tap from a hardware store or with super-fast delivery from Amazon – A good value thread tap set can be found on the Amazon store here.
The vehicle jack will need to be relocated elsewhere in the vehicle – We can supply a jack relocation bracket to move it into the rear corner of the tub (see below).
Installed on the driver-side of the cab back wall.
Includes pre-cut holes for one twin-midi fuse holder.
Includes pre-cut holes for the iTech World battery monitor shunt.
Installation of the battery mounting bracket takes around 30 minutes.
New bolts included.
Battery Charger
We can also supply a DCDC charger bracket to mount to the rear wall of the cab – See here for further details.
Battery Monitor
The battery mount includes pre-cut holes for a Victron or iTech Shunt to be installed directly above the battery. By using the optional battery monitor display bracket, you can fit the iTech or Renogy battery monitor display above the battery too.
Jack Relocation
When installing a battery behind the rear seats of a next-gen Ranger you will need to relocate the jack. We offer a relocation kit which provides a secure and easily accessible alternative mounting position for the jack in the rear corner of the tub – See further details here.
Material
Powder coated steel.
